In response to your important feedback on a variety of add-ons available for Train Simulator 2017, we have today released a patch for LNWR G2 Super D. [h1] Changelist [/h1] [b]New Liveries[/b] [list] [*]LMS Crimson Lake (Pre-1928) [*]LMS (Pre-1928) [/list] [b]New Features[/b] [list] [*]Trimmer assist [*]Priming notifications [*]High/Low water level notifications [*]Injector assist [*]Match lights to assist in seeing vacuum/pressure gauges temporarily at night. [/list] [b]Improvements/fixes[/b] [list] [*]Manual improvements [*]Fixed some sounds incorrectly set up as stereo format [*]Fixed fading distance for some sounds [*]Improved several sounds with new samples [*]Delayed activation added to steam sander [*]Fixed bug causing air deflector to appear on ai locomotives [*]Added particle effects for priming [*]Added particle effects for ejector failure [*]Added additional liveries to “G2A” numbers. [*]Improved adhesion model slightly so the locomotive wheels should spiral out of control during a slip as much. [*]Minor improvements to a select few particle emitters to hopefully increase performance slightly [*]Some script optimisation to hopefully increase performance a little [*]Optimisation of the steam chest simulation so it should now be much more steady under low fps conditions. [*]Stopped engine blowing back in tunnels [*]Stopped Wakefield lubricator drips appearing on non-Wakefield fitted engines [*]Altered Shaders to hopefully stop valve gear appearing through firebox when non-dynamic lighting is used. [*]Fixed left hand piston valve animation [*]Fixed an anachronism on the rear tender steps on engines without tender cabs. [*]Altered key to isolate ejector to hopefully prevent accidentally isolating the injector. [/list] This patch will be approximately 290MB. If you own the LNWR G2 Super D, the update will download automatically from Steam. If you have any problems/queries with regard to the update, leave a comment below or submit a ticket to our support site where our Support Team will be ready to assist.